T&S BRASS 001084-45
SEAT WASHER FOR DIVERTER VALVES AND OLD
SKU: TS001084-45
Condition: NEW
A diverter is used in restaurant equipment to deflect or redirect something else, such as a stream of fluid like water, or particles such as cubes or flakes in ice makers, or coffee beans and grounds in brewing equipment. A similar application is a diaphragm in a burner by which the flame and gases are brought together to improve combustion.
Valves are widely used in different restaurant equipment designs. A valve is a device that regulates, directs or controls the flow of a fluid (gases, steam, liquids, fluidized solids, or slurries) by opening, closing, or partially obstructing various passageways. In an open valve, fluid flows in a direction from higher pressure to lower pressure.
Valves may be operated manually, either by a handle, lever, pedal or wheel. Valves may also be automatic, driven by changes in pressure, temperature, or flow, allowing control over a variety of operational requirements.
A washer is a thin plate (typically disk-shaped, but sometimes square) with a hole (typically in the middle) that is normally used to distribute the load of a threaded fastener, such as a bolt or nut. Other uses are as a spacer, spring (Belleville washer, wave washer), wear pad, preload indicating device, locking device, and to reduce vibration (rubber washer). Spring washers, which have axial flexibility are used to prevent fastening or loosening due to vibrations. Locking (lock) washers prevent fastening or loosening by preventing unscrewing rotation of the fastening device.
T&S products are highly acclaimed throughout the industry for being well-built, long-lasting and reliable. Rigorous testing and a focus on interchangeability have helped set T&S apart from the competition for nearly 70 years.
HTS Category Code: 8208.30.00
UNSPC Category Code: 48100000
NAICS Code: 333241
Manufacturer Code: TS
Width: 3.05 in (7.75 cm)
Height: 0.2 in (0.51 cm)
Length: 6.1 in (15.49 cm)
Unit of Measure: Each (EA)