VALVE VENT W/CABLE TIES
Cables of many forms are pervasive in foodservice equipment. A cable is a wire or grouping of wires usually insulated and held together within an overall sheath. The assembly is used for the transmission of electrical power or electrical signals to and from various components within a piece of equipment. Cables may be housed internally such as with ribbon cables, or may be external such as with power cords. An electrical cable is an assembly of one or more wires running side by side or bundled, which is used to carry electric current.
A cable assembly is the composition of one or more electrical cables and their corresponding connectors. A cable assembly is not necessarily suitable for connecting two devices but can be a partial product (e.g. to be soldered onto a printed circuit board with a connector mounted to the housing). Cable assemblies can also take the form of a cable tree or cable harness, used to connect many terminals together.
A valve is a device that regulates, directs or controls the flow of a fluid (gases, steam, liquids, fluidized solids, or slurries) by opening, closing, or partially obstructing various passageways. Valves are technically fittings, but are usually discussed as a separate category. In an open valve, fluid flows in a direction from higher pressure to lower pressure.
Valves may be operated manually, either by a handle, lever, pedal or wheel. Valves may also be automatic, driven by changes in pressure, temperature, or flow. These changes may act upon a diaphragm or a piston which in turn activates the valve. More complex control systems using valves requiring automatic control based on an external input (i.e., regulating flow through a pipe to a changing set point) require an actuator. They can be electromechanical actuators such as an electric motor or solenoid, pneumatic actuators which are controlled by air pressure, or hydraulic actuators which are controlled by the pressure of a liquid such as oil or water. An actuator will stroke the valve depending on its input and set-up, allowing the valve to be positioned accurately, and allowing control over a variety of requirements.
A a vent is an opening through which air and other gases can pass.
Since 1957, Bunn-O-Matic Corporation (BUNN®) has been at the forefront of dispensed beverage equipment manufacturers. BUNN has become a global partner you can count on for reliable beverage equipment and outstanding post-purchase support wherever customers are served.
Click Image to Zoom In