VALVE INLET 24 VDC W/O FLOW WASHER
Frequently used in foodservice equipment, inlets are connectors that involve a service provider or holding tank to provide air, gas, water and other fluids in supplying a secondary component. An electrical inlet is a power connector that receives electrical power from a service provider.
A valve is a device that regulates, directs or controls the flow of a fluid (gases, steam, liquids, fluidized solids, or slurries) by opening, closing, or partially obstructing various passageways. Valves are technically fittings, but are usually discussed as a separate category. In an open valve, fluid flows in a direction from higher pressure to lower pressure.
Valves may be operated manually, either by a handle, lever, pedal or wheel. Valves may also be automatic, driven by changes in pressure, temperature, or flow. These changes may act upon a diaphragm or a piston which in turn activates the valve. More complex control systems using valves requiring automatic control based on an external input (i.e., regulating flow through a pipe to a changing set point) require an actuator. They can be electromechanical actuators such as an electric motor or solenoid, pneumatic actuators which are controlled by air pressure, or hydraulic actuators which are controlled by the pressure of a liquid such as oil or water. An actuator will stroke the valve depending on its input and set-up, allowing the valve to be positioned accurately, and allowing control over a variety of requirements.
A washer is a thin plate (typically disk-shaped, but sometimes square) with a hole (typically in the middle) that is normally used to distribute the load of a threaded fastener, such as a bolt or nut. Other uses are as a spacer, spring (Belleville washer, wave washer), wear pad, preload indicating device, locking device, and to reduce vibration (rubber washer). Spring washers, which have axial flexibility are used to prevent fastening or loosening due to vibrations. Locking (lock) washers prevent fastening or loosening by preventing unscrewing rotation of the fastening device.
Since 1957, Bunn-O-Matic Corporation (BUNN®) has been at the forefront of dispensed beverage equipment manufacturers. BUNN has become a global partner you can count on for reliable beverage equipment and outstanding post-purchase support wherever customers are served.
Click Image to Zoom In